
User’s Manual
ECM-LX800W Series User‘s Manual 53
H/W strapping
Manual settings.
Allows the clock speed to either be determined
by the hardware strapping or manual settings.
measures the ratio of an internal CPU clock rate
to the externally supplied clock
measures the ratio of an DDR RAM clock rate to
the externally supplied clock
Auto, 1.5CLK, 2CLK,
2.5CLK, 3CLK,3.5CLK
Allows the configuration Column Address
Select latency.
Auto, 15us, 3us, 7us,
31us, 62us 125us
Allows the setting of the memory refresh rate.
Options include:
Allows the manual or auto configuration of the
memory latencies
Minimum number of clocks from the ACT to PRE commands on the
same component bank
Minimum number of SDROM clocks between PRE and ACT commands
Minimum number of SDRAM clocks between ACT and Read/Write
Commands
Minimum number of SDRAM clocks between ACT and ACT commands
to two different component banks within the same module bank.
Minimum number of SDCLKS 90-31) between refresh and next
command, usually an activate
Disable,
8 M, 16 M, 32 M, 64 M,
128 M, 254 M.
This item allows to select video memory size.
Flat Panel,
CRT Monitor,
Panel & CRT.
This item allows to select video memory size
This item allows you to enable the onboard
audio function.
This item allows you to enable the onboard
USB1.1 function.
This item allows you to enable the onboard
USB2.0 function.
This item allows you to enable the onboard
IDE function.
The choices: Enabled, Disabled.
This item allows you to reserve the memory
area for some specific ISA card‘s use.
Comentarios a estos manuales